滑觸線在使用過一段時間后肯定會出現一些預想不到的故障，及時發現及時處理是非常的重要，今天就要為大家講講滑觸線在出現故障后應該如何處理。

　　The sliding contact line in use after a period of time there will be some unexpected failures, timely detection and timely treatment is very important today to the sliding contact line as we talk about how to deal with after a failure.

　　1、我們在使用滑觸線的時候會出現火花，主要還是因為其表面和導體之間的接觸不良原因?qū)е碌�，我們可以檢查接頭，發現問題及時處理

　　1, when we use sliding touch wire will appear sparks, mainly because of its surface and conductor contact between bad reasons, we can check the joints, and found the problem in time processing

　　2、當電流過大的時候集電器設備的行走就會變得有問題，處理這樣情況我們可以采用增加電器數量，調整連接導軌就可以了。

　　2, when the current is too large, the collector equipment will become a problem of walking, to deal with this situation, we can increase the number of electrical appliances, adjust the connection rail on it.

　　3、滑觸線的表面的外殼會經常有裂開，主要還是因為其導體的變形所導致的，處理這樣的情況我們可以增加提掛架的辦法來解決。

　　3, the surface of the sliding contact surface will often crack, mainly because of the deformation of its conductor, and in dealing with this situation, we can increase the lifting rack method to solve.

　　4、要是出現斷電的情況可能就是因為電刷的磨損很大而且也不能與導致所接觸或者是直接松脫，處理這樣的情況我們可以先檢查其磨損情況，看看是否要更換新的，然后在檢查連接點。

　　4, if appear the situation of power is possible because the brush wear big but not with the resulting contact or direct loose, dealing with such a situation we can first check the wear situation, whether to replace the new, then the connection point in check.

　　5、滑觸線要是出現很大的晃動可能是因為拔叉無法吸收傳動誤差所導致的，解決辦法就是，我們可以修正牽引器減少誤差和調整導軌。